Panasonic BB-HCS301A Getting Started Manual page 2

3.
Set up this product to view on the LAN.
Important
•
To avoid any possible problems, temporarily disable any firewall
or antivirus software.
•
This procedure explains installation of this product on the same
network as your PC.
•
Before proceeding, close your web browser.
Insert the Setup CD-ROM into the CD-ROM drive of the PC.
(If the Network Camera Setup window is not displayed automatically,
double-click the "Setup.exe" file on the Setup CD-ROM.)
Click [Camera Setup].
• If the Windows Security Alert is displayed, click [Unblock].
Select this product to set up and click [Execute].
This program searches for this product that are connected to the router
•
and displays their MAC Addresses, IP addresses and Port Numbers.
MAC
Address
Port Status
IP No.
Address
• The MAC Address on the bottom (see page 11 of the Operating Instructions
on the Setup CD-ROM.) of this product shows which product you select on
the List window.
Notes
• If the indicator does not light green, check the connection. (see page 10 of
the Operating Instructions on the Setup CD-ROM).
• If more than 20 minutes have passed since this product was turned on, this
product cannot be set up from the Setup Program. Disconnect the AC cord
from the outlet, and reconnect it again, and restart the Setup Program.
• The Setup Program may not list this product due to your firewall or antivirus
software settings on your PC. If you cannot disable your firewall or antivirus
software, you can set up this product by entering this product MAC address
on the following window. The product's MAC address can be found on the
label affixed to the bottom of each product. See page 11 of the Operating
Instructions on the Setup CD-ROM for details.
Displays version information
about this program.
Sets up this product or the camera.
Displays the manuals.
If your PC does not have Adobe ®
Acrobat ® Reader ® , install it from
the Adobe Reader website.
Installs Network Camera Recorder
trial version.
Closes the Setup Program.
List window
Displays IPv4 or
IPv6 information.
Click [Automatic Setup (Local Access Only)].
Enter the user name and password, and click [Save].
Enter the user name and password that were set, and
click [OK].
When the Single Camera page is displayed, setup is
completed.
• If the Security Warning window is displayed when installing ActiveX
Controls, click [Yes].
To install ActiveX Controls on Microsoft
•
2, see "Security Warning window on Microsoft Windows XP Service
Pack 2" on the last page.
Click [Next] to set up the Internet access to this
product and go to step
to this product." on the next page.
• Click [Cancel] to finish setup.
® ®
Windows XP Service Pack
Notes
• Some cameras may display black
lines at the end on the image due to
the gap of the display area. Adjust
the picture position (see page 67 of
the Operating Instructions on the
Setup CD-ROM).
• To ensure that the most current
image is displayed, Internet Explorer
should be configured as follows. This
will not have a negative effect on
normal use.
1. While viewing any website, click
[Tools] [Internet Options].
2. In the section "Temporary Internet
Files", click [Settings] and check
[Every visit to the page].
in "Set up Internet access
®