Drive Status Indicators - Allen-Bradley PowerFlex 753 Quick Start Manual

Drive Status Indicators

Table 41 - PowerFlex 753 Status Indicator Descriptions
Table 42 - PowerFlex 755 Status Indicator Descriptions
Name Color State
STS Green Flashing
(Status)
Steady
Yellow Flashing
Steady
Red Flashing
Steady
Red / Flashing
Yellow Alternately
Yellow / Flashing
Green Alternately
Green / Flashing
Red Alternately
Name Color State
STS Green Flashing
(Status)
Steady
Yellow Flashing
Steady
Red Flashing
Steady
Red / Flashing
Yellow Alternately
Yellow / Flashing
Green Alternately
Green / Flashing
Red Alternately
ENET Unlit Off
Red Flashing
Steady
Red / Flashing
Green Alternately
Green Flashing
Steady
LINK Unlit Off
Green Flashing
Steady
Rockwell Automation Publication 750-QS001A-EN-P - March 2015
Description
Drive ready but not running, and no faults are present.
Drive running, no faults are present.
Drive is not running, a start inhibit condition exists and the drive cannot be started.
See parameter 933 [Start Inhibits].
A type 1 (user configurable) alarm exists. If the drive is stopped, it is prevented from
starting until the alarm condition is cleared. If the drive is running, it continues to
run but cannot restart until the alarm condition is cleared.
See parameters 959 [Alarm Status A] and 960 [Alarm Status B].
A major fault has occurred. Drive stops. Drive cannot be started until fault condition
is cleared. See parameter 951 [Last Fault Code].
A non-resettable fault has occurred.
A minor fault has occurred. When running, the drive continues to run. System is
brought to a stop under system control. Fault must be cleared to continue. Use
parameter 950 [Minor Flt Cfg] to enable. If not enabled, acts like a major fault.
When running, a type 1 alarm exists.
See parameters 959 [Alarm Status A] and 960 [Alarm Status B].
Drive is flash updating.
Description
Drive ready but not running, and no faults are present.
Drive running, no faults are present.
Drive is not running, a type 2 (non-configurable) alarm condition exists and the
drive cannot be started. See parameter 961 [Type 2 Alarms].
A type 1 (user configurable) alarm exists. If the drive is stopped, it is prevented from
starting until the alarm condition is cleared. If the drive is running, it continues to
run but cannot restart until the alarm condition is cleared.
See parameters 959 [Alarm Status A] and 960 [Alarm Status B].
A major fault has occurred. Drive stops. Drive cannot be started until fault condition
is cleared. See parameter 951 [Last Fault Code].
A non-resettable fault has occurred.
A minor fault has occurred. When running, the drive continues to run. System is
brought to a stop under system control. Fault must be cleared to continue. Use
parameter 950 [Minor Flt Cfg] to enable. If not enabled, acts like a major fault.
When running, a type 1 alarm exists.
See parameters 959 [Alarm Status A] and 960 [Alarm Status B].
Drive is flash updating.
Embedded EtherNet/IP is not properly connected to the network or needs an IP
address.
An EtherNet/IP connection has timed out.
Adapter failed the duplicate IP address detection test.
Adapter is performing a self-test.
Adapter is properly connected but is not communicating with any devices on the
network.
Adapter is properly connected and communicating on the network.
Adapter is not powered or is not transmitting on the network.
Adapter is properly connected and transmitting data packets on the network.
Adapter is properly connected but is not transmitting on the network.
Reference Section
65