Testing The System; About Test Procedures; System Test - ADT Safewatch Pro 3000 Installaton Manual

Hide thumbs Also See for Safewatch Pro 3000:

User manual (57 pages)

System manual (14 pages)

Programming manual (16 pages)

Table Of Contents

Table of Contents

• • • • • • • • • • • • • • • • • • • • • • • • • • • • • • • • • • • • • • •

About Test Procedures

After the installation is complete, you should perform the following tests:

System Test:

Dialer Test:

Go/No Go Test:

RF Sniffer Mode:

Battery Tests:

System Test

With the system in the disarmed state, check that all zones are intact (not faulted). Doors and

windows with contacts should be closed, PIRs should be covered (use a cloth to mask them

temporarily if necessary). If a "NOT READY" message is displayed, press [∗] to display the faulted

zone(s). Restore faulted zone(s) if necessary, so that the "READY" message is displayed.

1. Enter Installer Code + 5 [ TEST ] , then press "0" at the prompt to start Walk Test mode.

1=DIAL, 0=WALK

The following will be displayed:

TEST IN PROGRESS

A Contact ID report will also be sent (code 607)

2. Upon entering the system test mode, the outside sounder should sound for 1 second.

If the backup battery is discharged or missing, the sounder may not turn on and a "LOW

BATTERY" report will be transmitted with a "TEST" report.

The touchpad will beep once per minute as a reminder that the system is in the Test mode.

NOTE: Wireless motion detectors (Passive Infrared units) will send signals out only if they have

been inactive for 3 minutes (conserves battery life).

3. Test all sensors using the procedure described in the User's Guide "Testing the System" section.

4. After checking sensors, turn off the test mode by entering installer code + OFF.

NOTE: Test mode automatically ends after 4 hours.

Checks that all zones have been installed properly and the system properly

responds to faults.

Checks that the phone connection to the central station is working properly.

Checks that transmissions can be received from transmitters. Should be

performed before permanently mounting transmitters.

Checks that RF transmitter serial numbers have been properly entered into the

system.

Automatic battery tests are performed by the system. See Automatic Battery Test

paragraph for details.

("dd" displayed on English Display Touchpads)

S E C T I O N