Pioneer DJD-707 Service Manual page 127

5
27 Level meters
Displays CH-1 and CH-2 peak levels or master output (stereo)
peak levels (see also item 34).
28 Cross fader REVERSE indicator
Indicates that the front panel's FADER REVERSE switch has been
set so that the cross fader now operates in reverse
(left side is CH-2, right side is CH-1) (see also front panel item 38).
29 Cross fader lever
When the lever is moved to the left side, CH-1 is at maximum
output and CH-2 is at minimum. When moved to the right side,
CH-2 is at maximum output and CH-1 is at minimum.
∗
The cross fader curve can be adjusted individually for CH-1
and CH-2 by means of the front panel FADER CURVE dials.
30 Operating load adjust screw (FEELING ADJ.)
The hexagonal Allen screw located next to the panel's slider
opening can be rotated with a hexagonal Allen driver to adjust the
sliding resistance of the cross fader lever.
31 CH-2 FADER START button
When this button is set to On, fader start and back cue can be
performed on the CH-2 CD player.
Whether the operation is initiated by operation of the CH-2 fader
lever, or by the cross fader lever is determined by the position of
the front panel's FADER START selector switch; the selection is
indicated by the lighting of the top panel's
CH-2 FADER START indicator or C.F.2 FADER START indicator.
32 CH-2 output On/Off lever (TRANSFORM)
Use to set CH-2 output to On or Off (Mute).
This lever's setting angle can be changed in 45° increments
(changing of the angle should be performed by an authorized
Pioneer service technician).
33 CH-2 REVERSE indicator
When lighted, indicates that the front panel's FADER REVERSE
switch has been set so that the CH-2 fader lever operates in the
reverse direction (see front panel item 38).
34 MASTER LEVEL display button and indicator
When depressed to the On position, the indicator lights and the
level meters display the master output (stereo) peak levels. When
turned Off, the level meters display the peak levels for CH-1 (left)
and CH-2 (right) (see also item 27).
35 CH-2 fader lever
The CH-2 fader lever is used to control the level of signals sent to
the cross fader. Signal level is maximum at scale mark "10," and
minimum at scale mark "0".
When the front panel CH-2 FADER REVERSE switch is set to
[ON], the signal level is maximum at scale mark "0," and
minimum at scale mark "10".
∗
The channel fader curve can be adjusted by means of the front
panel FADER CURVE dials.
36 CH-2 FADER START indicator
Lights when the CH-2 fader start/back cue function is enabled
(see also top panel item 31 and front panel item 39).
37 C.F.2 FADER START indicator
Lights when CH-2 cross-fader start/back cue function is enabled
(see also top panel item 31 and front panel item 39).
5
6
DJM-707
6
7
7
8
A
B
C
D
E
F
127
8