Table of Contents
Advertisement
Operating Instructions
Busch-AudioWorld
Pos: 80 /#Neustruktur#/Online-Dokumentation (+KNX)/Überschriften (--> Für alle Dokumente <--)/2. Ebene/M - O/Montage @ 18\mod_1302615960458_15.docx @ 103424 @ 2 @ 1
7.2
Mounting
Pos: 81 /#Neustruktur#/Online-Dokumentation (+KNX)/Sicherheitshinweise und Hinweise (--> Für alle Dokumente <--)/Hinweise - Sachschäden/Achtung - Beschaedigung durch harte Gegenstaende @ 24\mod_1339419856381_15.docx @ 216486 @ @ 1
Pos: 79 /Busch-Jaeger (Neustruktur)/Online-Dokumentation/Sicherheitshinweise und Hinweise (--> Für alle Dokumente <--)/Hinweise - Sachschäden/Achtung - Beschaedigung durch harte Gegenstaende @ 24\mod_1339419856381_1.docx @ 216485 @ @ 1
Caution
The device can sustain damage when coming into contact with hard objects!
The plastic parts of the device are sensitive.
–
Pull the attachment off only with your hands.
-
Do not lever parts off with screwdrivers or similar hard objects.
Pos: 82 /#Neustruktur#/Online-Dokumentation (+KNX)/Montage/alle Geräte/Montage - UP-Dosen - DIN 49073-1 oder geeignetes Aufputzgehaeuse - Ohne Docvariable @ 25\mod_1340354979636_15.docx @ 219890 @ @ 1
The flush-mounted insert must only be installed in flush-mounted wall boxes according to DIN 49073-1, Part 1, or
suitable surface-mounted housings.
Pos: 83 /#Neustruktur#/Online-Dokumentation (+KNX)/Montage/alle Geräte/Montage -- UP-Geraete mit Display @ 24\mod_1339418028506_15.docx @ 216473 @ @ 1
1. Pull the attachment off.
-
If the device is already mounted or assembled, pull off the
attachment from the flush-mounted-insert with the aid
of the frame.
–
If the state of the device is at the point of delivery, pull
off the attachment from the flush-mounted-insert with
your hands.
–
Pull the attachment off only with your hands!
Do not lever parts off with screwdrivers or similar hard
objects. This damages the device.
–
When pulling off, first the resistance of the spring
clamps must be overcome.
In addition to the integrated antenna, an external antenna can be connected to the corresponding connector.
2. For the selection of the antenna set the switch on the rear
of the device on "Internal" or "External".
-
Connecting lamps or electronic transformers to the
same phase can cause interference to reception. In
this case, always use an external antenna.
Operating Instructions | 1473-1-7955
®
Installation and electrical
Fig. 18: Wall mounting: pulling off the attachment
Fig. 19: State of the device at the point of delivery:
pulling off the attachment
connection
— 26 —
Advertisement
Table of Contents
