Chapter 2. Setting Up The Projector; Starting And Shutting Down The Projector - Lenovo C500 User Manual

Hide thumbs Also See for C500:

Table of Contents

Chapter 2. Setting up the projector

This chapter provides information on positioning the projector, connecting a computer source, using the

projector with Microsoft Windows, and displaying and adjusting a computer source image.

Please follow the steps below to start your projector, and to shut off the projector.

Attention: Before moving the projector, be sure to power down the projector normally and disconnect

the projector from the main power source.

1. Connect the power cord to the projector as shown. Connect the other end to a wall outlet. The Power

LED turns on and the buttons illuminate.

2. Remove the lens cover.

3. Attach input devices.

4. Turn on the connected devices.

5. Ensure the Power LED is on a steady (not flashing) orange and then press the Power button to turn

on the projector. The projector splash screen displays and connected devices are detected.

Figure 2-1. Lenovo splash screen

Attention: Do not look directly into the projection lens when the lamp is turned on. The bright light

might harm your eyes.

6. Use the appropriate appliance cable to connect to a video device.

7. To turn off the projector, press the Power button. The projector prepares for shut-down and a "Wait a

moment please..." message appears, as shown below.

Downloaded From projector-manual.com Lenovo Manuals

2-1

Table of Contents