Replacing The Vacuum Pump Oil Pump Assembly (Gpod); Removal; Refitting - Iveco daily euro 4 Repair Manual

172
F1C ENGINE
Figure 17
Fit a new centrifugal filter (1).
Fit a new snap ring (2).
Fit cover (3), and then tighten screws (4) to the specified
torque.
NOTE Both centrifugal filter (1) and cover (3) seal ring
must be replaced every time they are dismounted.
Re-attachment is carried out by reversing the order of
detachment operations. In particular, tighten the screws and
nuts to the specified torque values.
After re-attachment has been completed, fill the engine
cooling system, check the engine oil level (top up, if
necessary), start the engine and check for cooling fluid leaks.
Base - March 2006
503010 REPLACING THE VACUUM PUMP
OIL PUMP ASSEMBLY (GPOD)

Removal

Remove the front cover, as described in the "Replacing the
drive shaft seal ring and the front cover gasket" chapter.
Figure 18
1
2
102217
3
Remove screws (3), and then take off vacuum pump oil pump
assembly (2).
Remove connecting joint (1) from gear (4).

Refitting

Position connecting joint (1) into gear (4).
Fit vacuum pump oil pump assembly (2) by placing
a new gasket in between.
Tighten screws (3) to the specified torque.
Re-attachment is carried out by reversing the order
of detachment operations. In particular, tighten the
screws and nuts to the specified torque values.
After re-attachment has been completed, fill the
engine cooling system, start the engine and check for
cooling fluid leaks.
D E 4
AILY URO
4
102218
Print 603.93.651