Other Functions - Sanyo ASW-90WRT Instruction Manual

OTHER FUNCTIONS

Function of fault alarm
Fault Cause of fault
Alarm for
Entering water less than 16
water inlet
minutes, reset water level.
Open the LID after starting
Alarm for
the delay time. Open the LID
opening lid
when the washer is spinning.
Checked imbalance for the
Imbalance alarm
third time.
After draining for 4 minutes,
Drain alarm
does not finish to drain.
Automatic power shut off
1. If the machine is not started within 10 minutes after powered on, it will power off automatically
2. If the machine is not powered off until the buzzer sounds 6 times after the operation, it will power off
automatically
Adjusting for unbalance
1.If the laundry is placed uneven before spinning, it causes excessive vibration of spinning. The washing
machine has a function of adjusting unbalance. During cycles, the washing machine always inspects running
state. If the spinning vibration is too big, the washing machine automatically starts the adjusting program to
balance.
2. If the washing machine detects the unbalance even after the adjustment, it will alarm.
Alarm of the
Indication Stopping alarm
buzzing sound
The buzzer goes Open the lid to
deal with faults,
on buzzing for
E1
10 seconds. If then close the lid
the fault is not to stop the alarm.
solved , buzzes
again for 10
E2 seconds in every
16 minutes.
E3
E4
14
WASH/SPIN TUB
WASH/SPIN TUB
WASH/SPIN
WASH/SPIN TUB
WASHER
LID
CONTROL PANEL .
WASH/SPIN TUB
WASH/SPIN TUB
1.the appliance is not intended for use by young children or infirm persons without supervision.
2.Young children should be supervised to ensure that they do not play with the appliance.
POWER PLUG
POWER CORD
POWER CORD
POWER CORD
POWER PLUG
WASH/SPIN TUB
15