Maintenance - Sanyo ASW-90WRT Instruction Manual

METHOD OF MAINTENANCE
The following cases are not faults
1.There is water inlet during washing or rinse, which is due to the washer senseing a lack of water and
changes water level automatically.
2.There is the phenomenon of intermittent spinning in the beginning of spinning, which is performed to achieve better spinning
effects.
3. In the course of spin, the program returns to the wash program. This is designed to rectify unbalanced distribution of load in
the WASH/SPIN TUB.

Maintenance

After the whole washing program
The washing machine will make buzzer sound after
end of any program operation to remind you to
taking out the laundry or operate it again.
After finishes washing, shut off the tap, and pull out
the plug in case of water leakage or fire accident.
Cleaning the water inlet
After prolonged use, the WA TER INLET MESH may be
blocked, and should be cleaned according to the
following steps:
1. Switch on the power, followed by shutting off the tap .
2. Let the washer work for 5 seconds so that water flows
into the tub through the water inlet hose. Then turn off
the power.
3.Disconnect the water inlet hose and clean the mesh
Bag. Then restore the water inlet assembly.
Maintenance of shell
Use a soft cloth to wipe off the
water and dirt on the surface each
time after use of the washing
machine. Detergent, propellant
and other chemicals are not
allowed to use, for they can cause
damage to the surface.
Cleaning of the LINT FILTER
After using the washing machine for a period, clean it
according to the following steps:
1. Take out the lint filter.
2. Turn the mesh bag inside out and wash it clean in the water.
3. Restore it and refix it.
12
TROUBLE SHOOTING
Exceptional
Cause
phenomenon
The power plug is not plugged tight.
The power switch is not switched on.
No indication
Not press "START/P AUSE" button.
in controller
Power cut.
The INLET HOSE is not firmly
The inlet hose
connected with tap.
leakage WA TER INLET HOSE is not screwed
tight.
The DRAIN HOSE is caught or
Does not drain
jammed.
Off water.
Not on tap.
Dose not inject water
Whether the wire netting in the WA TER
INLET was blocked.
Spinning stops and
Cause by that the washing placed
water injecting begains
uneven.
in the course of spin
After draining, the lid is not correctly.
Does not spin
Open the lid during spinning.
The maintain a better spinning
Intermittent spinning
effect.
Before using the machine
Remainning water due to testing or
water exists
experiment in the factory.
in the drain hose.
Notices:
If there is still abnormal circumstances after checking the above-mentioned points, please pull out the plug.
Do not repair it by yourself at home, which is very dangerous.
13
Solution
Re-plug the power plug.
Check the power socket, or change other socket.
Press "START/P AUSE" button.
Wait for switching on electricity.
Check the connection.
Screw tight the nut.
The drain hose is made swimmingly, and
solve the problem of jam.
Wait for supply water.
Open the tap.
Clean the msh according to the method of
"Cleaning of the water inlet".
This is automatic rectification for spinning in
the washing program. That the washing are too
much or too little, or that the washing machine
is not placed plane will cause the unbalance in
time of spinning. If there is still abnormal
circumstances after checking the above-
mentioned points, please pull out the power
plug and contact with local service as soon as
possible.
The LID is not closed correctly.
This is normal .
This is normal .