Adjusting Trim Angle For Manual Tilt Models; Adjusting Trim Angle (Power Tilt Models) - Yamaha F15 Owner's Manual

EMU27872
Adjusting trim angle for manual tilt
models
There are 4 or 5 holes provided in the clamp
bracket to adjust the outboard motor trim an-
gle.
1. Stop the engine.
2. Tilt the outboard motor up, and then re-
move the trim rod from the clamp brack-
et.
1
1. Trim rod
3. Reposition the rod in the desired hole.
To raise the bow ("trim-out"), move the rod
away from the transom.
To lower the bow ("trim-in"), move the rod to-
ward the transom.
Make test runs with the trim set to different
angles to find the position that works best for
your boat and operating conditions.
EWM00400
WARNING
Stop the engine before adjusting the

trim angle.
Use care to avoid being pinched when

removing or installing the rod.
Use caution when trying a trim position

for the first time. Increase speed gradu-
ally and watch for any signs of instabil-
ity or control problems. Improper trim
angle can cause loss of control.
TIP:
The outboard motor trim angle can be
changed approximately 4 degrees by shifting
the trim rod one hole.
EMU27905
Adjusting trim angle (power tilt
models)
EWM00753
Be sure all people are clear of the out-

board motor when adjusting the trim
angle. Body parts can be crushed be-
tween the motor and the clamp bracket
when the motor is trimmed or tilted.
Use caution when trying a trim position

for the first time. Increase speed gradu-
ally and watch for any signs of instabil-
ity or control problems. Improper trim
angle can cause loss of control.
ZMU05601
If equipped with a power trim and tilt

switch located on the bottom cowling,
use the switch only when the boat is at
a complete stop with the engine off. Do
not adjust the trim angle with this
switch while the boat is moving.
1. Move the gear shift lever to the neutral
position.
TIP:
While the boat is moving, it may be difficult to
adjust the trim angle due to water pressure.
Before adjusting the trim angle, reduce the
boat speed and shift into neutral.
2. Tilt the outboard motor to the desired an-
gle using the power tilt switch.
WARNING
Operation
57