Toro 04202 Operator's Manual page 8

110-2304 Narrow Wiehle
110-2305 Wide Wiehle
110-2306 Full Roller
110-2303 Rear Roller
Use the following table and Figure 12 to set the rate of clip.
Drive pulley number
of teeth
27 (standard)
22
22
The reel is shipped with one 27 tooth and one 22 tooth pulley. To get a .16 inch (4 mm) clip, you must purchase
a 22 tooth pulley. The clip can only be changed on the reel drive (Figure 12). Do not change the drive ratio
on the gearbox pulleys.
1. Reel drive belt
2. Drive pulley
Flex 18
Flex 18
Flex 18
Flex 18
Clip (Refer to Figure 12 for pulley locations.)
Driven pulley number 14 Blade Clip inch (mm) 11 Blade Clip inch (mm)
of teeth
22 (standard)
22
27
2.5 inches (63.5 mm)
Aluminum
2.5 inches (63.5 mm)
Aluminum
2.5 (63.5 mm) inches Steel
2.0 inches (50.8 mm)
Aluminum
0.112 (2.9) 0.143 (3.6)
0.138 (3.5) 0.176 (4.5)
0.172 (4.4) 0.219 (5.6)
Figure 12
3. Driven pulley
8
Standard Front
More Penetration
Least Penetration
Standard Rear
8 Blade Clip inch (mm)
0.197 (5.0)
0.241 (6.1)
0.301 (7.7)