Table of Contents
Advertisement
Replacing the Scraper
The scraper is located at the bottom of the rotor housing
as shown in Figure 10.
2
1
Figure 10
1. Scraper
1. Remove the 2 screws that secure the scraper to the
snowthrower (Fig. 10).
2. Install the new scraper and fasten it securely with
2 screws.
Replacing the Rotor
1. Remove the 3 screws that secure the right side cover
and the skid to the snowthrower frame (Fig. 11).
1
Figure 11
1. Right side cover
2. Screw
2
1517
2. Screw
2
3
1537
3. Skid
10
2. Use a 5/16-inch Allen wrench to turn the rotor shaft
clockwise (left-hand thread) while holding the rotor
(Fig. 12).
1
Figure 12
1. Rotor shaft
Note: You may need to tap the Allen wrench with a
hammer to loosen the rotor shaft. Wedge a stick or a
hammer handle in the rotor to prevent it from rotating.
Note: If you cannot remove the rotor shaft by holding the
rotor, remove the left side cover and the skid (Fig. 13).
2
Figure 13
1. Left side cover
3. Hold the hex nut with a 7/8-inch wrench while
unscrewing the rotor shaft (Fig. 14).
1
Figure 14
1. Hex nut
4. Hold the rotor and pull out the rotor shaft.
5. Remove the rotor.
2
1538
2. Rotor
1
1539
2. Skid
1525
Advertisement
Table of Contents
