Setup; Installing The Castor Wheel Assemblies - Toro 30716 Operator's Manual

Setup

Loose Parts
Use the chart below to verify that all parts have been shipped.
Procedure
1
2
3
4
5
6
7
8
Media and Additional Parts
Description
Parts Catalog
Operator's Manual
Note: Determine the left and right sides of the machine
from the normal operating position.
1
Installing the Castor Wheel
Assemblies
Parts needed for this procedure:
2 Large castor wheel assembly
2 Small castor wheel assembly
Procedure
The thrust washers, spacers, and tensioning caps have been
installed on the castor wheel spindles for shipping.
Description
Large castor wheel assembly
Small castor wheel assembly
Drive shaft
No parts required
No parts required
Bolt, 5/16 x 1-3/4 inches
Locknut, 5/16 inches
Roll pin, 3/16 x 1-1/2 inches
No parts required
No parts required
No parts required
Qty.
2
2
1
–
–
2
2
2
–
–
–
Qty.
1
Review the material and save in an appropriate place:
1
1. Remove the tensioning caps from the spindle shafts
and slide off the spacers and thrust washers (Figure
2 & Figure 3).
1. Tensioning cap
2. Thrust washers
2. Slide the spacers onto the castor spindle to get the
desired height-of-cut; refer to the Height-of-Cut Chart
8
Use
Install the castor wheel assemblies.
Install the drive shaft to the traction unit
Connect the right-hand push arm to the
cutting unit
Connect the left-hand push arm to the
cutting unit
Connect the drive shaft to the cutting
unit gear box
Install the lift chains
Grease the machine.
Install rear weight
Use
Figure 2
3. Spacers
4. Large (front) castor spindle