Setting Of Pin (Personal Identity Number) Code; Connection Of The Registered Bluetooth; Disconnection Of The Bluetooth; Deletion Of The Registered Data - Panasonic CQ-BT5107U Operating Instructions Manual

Notes :
¡
We shall not guarantee all the functions of the
Bluetooth ® device to be connected. When
operations cannot be performed via this unit,
operate the system via the Bluetooth
¡
Be aware that the battery of a Bluetooth
drains faster if the Bluetooth
connected to this unit.

Setting of PIN (Personal Identity Number) code

1
Hold down [6] for more than 2 seconds to
call the PIN code entry mode.
2
Press [6] to prepare for adjustment.
3
Enter a number for each digit.
[s] / [d] : Selects number (0 – 9).
: Selects next digit to be entered.
[6]
4
Press [6] to determine the PIN code entry
when last digit is entered.

Connection of the registered Bluetooth

device to this unit
1
Press the preset button(s) [1] through [6] to
select the registration number of the
Bluetooth ® device of interest. (Refer to the
above.)
2
Hold down [BAND] for more than 2 seconds
for connection.
The Bluetooth ® indicator ( ) lights.
Notes :
¡
Even if [SRC] (Source) is pressed to change the
source, the connection stays connected.
¡
Depending on the communication status, it may
takes 5 to 40 seconds for device connection.
¡
® device.
¡
® device
® device is
¡

Disconnection of the Bluetooth

Hold down [BAND] for more than 2 seconds.
Note : When the Bluetooth
reception range or encounter serious interference
1st digit blinks
by outer signal, "ERROR" appears and this unit will
automatically disconnect the connections.

Deletion of the registered data

1
Digit entered
Completed
2
®
3
4
Even when the Bluetooth ®
connected to this unit is located near this unit,
sound may be interrupted or noise may be
generated.
The Bluetooth ® device with over 5-digit PIN
code is not operated with this unit.
"DISCONN." (DISCONNECT) is displayed when
the Bluetooth ® device is disconnected.
The Bluetooth ® indicator ( ) turns off.
®
Press the preset button(s) [1] through [6] to
select a registration number assigned to the
Bluetooth ® device whose data is to be
deleted. (Refer to the above.)
Hold down the preset button [1] through [5]
selected above for the registration number
for more than 2 seconds.
Press the preset button that was pressed at
the step above again.
Push [SEL].
device that is
® device
device is out of
Deletion
completed
CQ-BT5107U
17