Adjusting The Handle - Toro 04019 Operator's Manual

frame with the bolt and washer, the small spacer,
and locknut (M8–1.25) (Figure 9). Ensure the bolt
is installed from the inside of the frame as shown
in Figure 9.
3. Install a washer (M8) onto the large bolt (M8–1.25 x
100).
4. Install the spacer into the spring and install the large
bolt (M8–1.25 x 100) into the spacer.
Important: When installing the spring, place
one end of the spring under the rear frame
(Figure 9).
5. Install the left side of the kickstand to the frame
with the bolt and washer, the large spacer and spring,
and locknut (M8–1.25) (Figure 9). Ensure the bolt
is installed from the inside of the frame as shown
in Figure 9.
1. Left handle end
2. Locknut (M8–1.25)
3. Small spacer
4. Washer (M8)
6. Place a nut runner over the end of the spring pointing
towards the rear and move the end of the spring over
and under the kickstand spacer (Figure 10).
Figure 9
5. Large bolt (M8–1.25 x
100)
6. Spring
7. Large spacer
8. Ssmall bolt (M8–1.25 x
030)
1. Spring
2. Spring end under the
frame
4

Adjusting the Handle

No Parts Required
Procedure
1. Remove hairpin cotters from ring pins on each side
of mower (Figure 11).
1. Ring pins
2. While supporting handle, remove ring pins from
each side and raise or lower handle to desired
operating position (Figure 11).
3. Reinstall ring pins and hair pin cotters.
12
Figure 10
3. Nut runner
4. Move the spring end under
the kickstand spacer.
Figure 11