Maintenance; Recommended Maintenance Schedule - Toro 22305 Operator's Manual

Compact utility loader
Hide thumbs Also See for 22305:
Table of Contents

Advertisement

Maintenance

Note: Determine the left and right side of the machine from the normal operating position.

Recommended Maintenance Schedule

Maintenance Service
Interval
8 hours
25 hours
100 hours
200 hours
400 hours
Yearly/Storage
1
More often in dusty, dirty conditions.
2
Change oil after the first 50 operating hours.
3
Change the hydraulic filter and torque the lug nuts after the first 8-10 operating hours
4
For severe duty or rental applications, change every 100 operating hours.
5
For severe duty or rental applications, change every 200 operating hours.
6
For severe duty or rental applications, change every 400 operating hours.
Important
Refer to your engine operator's manual for additional maintenance procedures.
Note: After 50 hours and then every 100 hours thereafter (that is at 150, 250, 350, etc.) the screen displays CHG OIL to
remind you to change the oil. After every 100 hours, the screen displays SVC to remind you to perform the other
maintenance procedures based on a 100, 200, or 400 hour schedule. These reminders come on starting three hours prior to
the service interval time and flash at regular intervals for six hours.
If you leave the key in the ignition switch, someone could accidently start the engine and
seriously injure you or other bystanders.
Remove the key from the ignition and disconnect the wires from the spark plugs before you do
any maintenance. Set the wire aside so that it does not accidentally contact the spark plug.
Maintenance Procedure
Grease the traction unit
Check engine oil level
Check for loose fasteners
Check tire pressure (20 psi.)
1
Clean primary air filter
Check hydraulic oil level
Inspect hydraulic lines for leaks
1, 2
Change engine oil
Check battery electrolyte level
Check wheel lug nut torque (50 ft.-lb)
Check battery cable connections
Change engine oil filter (every other oil change)
Check engine speed (1400 rpm idle and 3600 full throttle,
Check spark plugs
1, 3, 5
Change hydraulic filter
Inspect fuel lines for leaks
1, 6
Change hydraulic oil
Replace primary and secondary air filters
1
Replace the fuel filter
Touch up chipped paint
Caution
24
3
1, 4
75)
1

Hide quick links:

Advertisement

Table of Contents
loading

This manual is also suitable for:

Dingo 32322312Dingo 322

Table of Contents