Table of Contents
Advertisement
Adjusting the Rollers
Mount the rollers in the lower position when operating in
height of cuts higher than 64 mm (2-1/2 inches) and in the
higher position when operating in height of cuts lower than
64 mm (2-1/2 inches).
1. Disengage the PTO, move the motion control levers to
the neutral locked position and set the parking brake.
2. Move the throttle lever to the Slow position, stop the
engine, remove the key, and wait for all moving parts to
stop before leaving the operating position.
3. Raise the front of the machine and support it on jack
stands.
4. Remove the fasteners securing each roller on your
mower deck and move the rollers up or down as
desired; refer to Figure 26 through Figure 30 as
applicable for your mower.
Figure 26
All Mower Decks
1. Front roller
Figure 27
Guardian Mower Decks Only
1. Bolt
2. Rear under-deck roller
3. Spacer
2. Roller shaft
4. Nut
5. Bracket
Guardian Mower Decks Only
1. Bolt
2. Front under-deck roller
Side-discharge Mower Decks Only
1. Bolt
2. Chute-side roller
3. Spacer
26
Figure 28
3. Nut
4. Bracket
Figure 29
4. Nut
5. Bracket
Advertisement
Table of Contents
