Testing The Safety System - Toro 71233 Operator's Manual

Danger
You could back over a child or bystander while the
mower blade(s) or other attachment is engaged
and cause serious injury or death.
Do not mow in reverse unless absolutely
necessary.
Do not insert the KeyChoice key unless it is
absolutely necessary.
Always look backward and down before
backing up.
Use the KeyChoice switch only if you are certain
no children or other bystanders will enter the
mowing area.
Be very observant after deactivating the
interlock because the sound of the engine may
prevent you from noticing that a child or
bystander has entered the work area.
Always remove both the ignition and KeyChoice
keys and put them in a safe place out of the
reach of children or unauthorized users when
leaving the unit unattended.
1. Engage the PTO.
2. Insert the KeyChoice key into the switch (Fig. 9).
Figure 9
1. KeyChoice switch
3. Turn the KeyChoice key.
A red light on the front console (Fig. 10) turns on,
indicating that the interlock is disabled.
1
Figure 10
1. Operating-in-reverse light
4. Shift into reverse and complete your task.
5. Stop the PTO of the engine to activate the interlock.
6. Remove the KeyChoice key and put it in a safe place
out of reach of children.

Testing the Safety System

Test the safety system before you use the machine each
time. If the safety system does not operate as described
below, have an Authorized Service Dealer repair the safety
system immediately. While sitting in the seat, perform the
following checks.
1. Set the parking brake. Move the PTO to Engaged. Turn
the ignition key to Start; the engine should not crank.
2. Move the PTO to Disengaged and release the parking
brake. Turn the ignition key to Start; the engine should
not crank.
3. Set the parking brake and move the PTO to Disengaged.
Start the engine. While the engine is running, release
the parking brake and rise slightly from the seat; the
engine should stop.
4. Put the PTO lever in the Disengage position, the
traction control pedal in neutral, and set the parking
brake. Start the engine. While the engine is running,
move the PTO lever to the Engage position and move
the traction control pedal to reverse. The engine should
stop.
5. Put the PTO lever in the Disengage position, the
traction control pedal in neutral, and set the parking
brake. Start the engine. Move the PTO lever to the
Engage position and turn the KeyChoice key and
release. The operating-in-reverse warning light should
illuminate. Move the PTO lever to the Disengage
position and the operating-in-reverse warning light
should turn off.
14
1
m–1863