Changing The Engine Oil - Toro 74919TE Operator's Manual

Changing the Engine Oil

Service Interval: After the first 8 hours
Every 100 hours (more often in dirty or dusty
conditions).
Note: Dispose of the used oil at a recycling center.
1. Start the engine and let it run for 5 minutes. This
warms the oil so it drains better.
2. Park the machine so that the rear is slightly lower than
the front to ensure that the oil drains completely.
3. Disengage the PTO, move the motion-control levers to
the neutral-locked position and set the parking brake.
4. Stop the engine, remove the key, and wait for all
moving parts to stop before leaving the operating
position (Figure 54).
Figure 54
5. Slowly pour approximately 80% of the specified oil
into the filler tube and slowly add the additional oil to
bring it to the Full mark
A
C
E
6. Start the engine and drive to a flat area. Check the oil
level again.
Changing the Engine-Oil Filter
Service Interval: Every 200 hours
Note: Change the engine-oil filter more frequently when
operating conditions are extremely dusty or sandy.
1. Drain the oil from the engine; refer to
Engine Oil (page
2. Change the engine-oil filter
40
(Figure 55).
B
D
F
g027660
Figure 55
Changing the
40).
(Figure 56).