Adjusting The Anti-Scalp Rollers - Toro 74919TE Operator's Manual

Adjusting the Height-of-Cut Pin
The height of cut is adjusted from 25 to 140 mm (1 to
5-1/2 inches) in 6 mm (1/4 inch) increments by moving the
clevis pin into different hole locations.
1. Move the transport lock to the lock position.
2. Push on the deck-lift pedal with your foot and raise the
mower deck to the transport position (also the 140 mm
(5-1/2 inch) cutting-height position); refer to
3. To adjust, rotate the pin 90 degrees and remove the pin
from the height-of-cut bracket
4. Select a hole in the height-of-cut bracket corresponding
to the height of cut desired, and insert the pin
27).
5. Push on the deck lift, pull back on the transport lock,
and slowly lower the mower deck.
Figure 27
1. Deck-lift pedal
2. Height-of-cut pin
Adjusting the Anti-Scalp
Rollers
Whenever you change the height of cut, it is recommended to
adjust the height of the anti-scalp rollers.
1. Disengage the blade-control switch (PTO), move the
motion-control levers to the neutral-locked position
and set the parking brake.
2. Stop the engine, remove the key, and wait for all moving
parts to stop before leaving the operating position.
Figure
(Figure 27).
(Figure
3. Transport lock
27.
1. Anti-scalp roller
2. Spacer
3. Bushing
1. Anti-scalp roller
2. Bushing
1. Anti-scalp roller
2. Spacer
3. Bushing
26
Figure 28
4. Flange nut
5. Bolt
Figure 29
3. Flange nut
4. Bolt
Figure 30
4. Flange Nut
5. Bolt