Table of Contents
Advertisement
Figure 73
1. Clutch pulley
2. Mower belt
3. Spring loaded idler pulley
4. Ensure belt-guide tab hits
against the pivot hub
12. Rotate and ensure the belt-guide tab hits against the
pivot hub
Figure
73.
13. Using the ratchet in the square hole, install the idler
spring
(Figure
73).
Make sure the spring ends are seated in the anchor
grooves.
14. Install the belt covers
5. Belt guide
6. Spring-loaded idler pulley
7. Square hole in the idler
arm for the ratchet
8. Spring
(Figure
74).
1. Position the belt cover
2. Slide belt cover under the
side catches
15. Install the sheet metal guard. Refer to
Sheet-Metal Guard (page
16. Tighten the bolt for the mower-deck curtain. Refer to
Releasing the Mower-Deck Curtain (page
Replacing the Hydraulic-Pump
Drive Belt
1. Disengage the blade-control switch (PTO) and set the
parking brake.
2. Shut off the engine, remove the key, and wait for all
moving parts to stop before leaving the operating
position.
3. Remove the mower belt; refer to
Deck Belt (page
4. Raise the machine and support it with jack stands
(Figure
75).
51
Figure 74
3. Ensure the tab is under
the metal catch
Removing the
32).
32).
Replacing the Mower
50).
Advertisement
Table of Contents
