Table of Contents
Advertisement
Adjusting the Height-of-Cut Pin
Adjust the height-of-cut from 25 to 140 mm (1 to
5-1/2 inches) in 6 mm (1/4 inch) increments by moving the
clevis pin into different hole locations.
1. Move the transport lock to the L
2. Push on the deck-lift pedal with your foot and raise
the mower deck to the Transport position (also the
140 mm or 5-1/2 inch cutting-height position) as
shown in
Figure
26.
3. To adjust, rotate the pin 90 degrees and remove the pin
from the height-of-cut bracket
4. Select a hole in the height-of-cut bracket corresponding
to the height-of-cut desired, and insert the pin
26).
5. Push on the deck lift, pull back on the transport lock,
and slowly lower the mower deck.
Figure 26
1. Deck-lift pedal
2. Height-of-cut pin
Adjusting the Anti-scalp
Rollers
Whenever you change the height of cut, adjust the height
of the anti-scalp rollers.
1. Disengage the blade-control switch (PTO), move the
motion-control levers to the N
and set the parking brake.
2. Shut off the engine, remove the key, and wait for all
moving parts to stop before leaving the operating
position.
position.
OCK
(Figure
26).
(Figure
3. Transport lock
-
position
EUTRAL
LOCK
3. Adjust the anti-scalp rollers as shown in
Figure 28
to match the closest height-of-cut position.
1
2
3
1. Flange nut
2. Anti-scalp roller
1
g024243
1. Bolt
2. Bushing
25
Figure 27
4
g024242
Figure 27
3. Bushing
4. Bolt
2
3
Figure 28
3. Anti-scalp roller
4. Flange Nut
and
4
Advertisement
Table of Contents
