Loose Parts; Installing The Upper Handle And Chute Crank - Toro 38026 Operator's Manual

Setup

Loose Parts

Use the chart below to verify that all parts have been shipped.
Step
1.
2.
Note: Determine the left and right sides of the machine from the normal operating position.
1. Installing the Upper Handle
and Chute Crank
1. Stand the snowthrower on its wheels and position the
upper handle.
2. Inspect the open internal wiring; if it is damaged, do not
assemble. Contact an Authorized Service Dealer.
The internal wiring could be damaged during
assembly, causing serious personal injury when
operating the snowthrower.
•
Carefully assemble the snowthrower so that
you will not damage the electrical wiring.
•
If the wiring is damaged, do not assemble the
snowthrower. Contact an Authorized Service
Dealer.
3. Carefully insert the right side of the upper tubing over
the end of the lower right side tubing (Figure 3).
Description
Mounting plate
Chute crank
Machine screw
Locknut
Chute deector
Rubber washer
Carriage bolt
Metal washer
Locknut
Qty.
1
1
Install the upper handle and chute
crank.
2
2
1
2
2 Install the discharge chute.
2
2
Figure 3
1. Upper tubing
4. Carefully insert the left side of the upper tubing into the
end of the lower left side tubing ().
5. Squeeze the upper tubes together, and wiggle the upper
tubes down until the mounting holes in the upper and
lower tubing line up (Figure 3).
6. Place the mounting plate over the tubes (Figure 4).
4
Use
2. Lower tubing