Check And Clean The Hydraulic Unit Shrouds - Toro 74923TE Operator's Manual

Check and Clean the Hydraulic
Unit Shrouds
Service Interval: Before each use or daily
Important: The fasteners on the covers of this machine
are designed to remain on the cover after removal.
Loosen all of the fasteners on each cover a few turns so
that the cover is loose but still attached, then go back
and loosen them until the cover comes free. This will
prevent you from accidentally stripping the bolts free
of the retainers.
1. Disengage the PTO and set the parking brake.
2. Stop the engine, remove the key, and wait for all moving
parts to stop before leaving the operating position.
3. Move the seat all the way forward.
4. Allow the engine to and hydraulic system to cool.
5. Clean the debris and grass from the hydraulic unit
shrouds (Figure 69).
1. Hydraulic unit shrouds
Figure 69
6. Over each dipstick, remove the cover and the bolt
attached to the cover . Clean around each dipstick and
hydraulic unit (Figure 70).
7. Adjust the seat.
1
1. Cover
46
2
Figure 70
2. Bolt
G012434