Setup; Installing The Pto Driveshaft To An Optional Mower Deck Or Qas - Toro 31236 Operator's Manual

Setup

Loose Parts
Use the chart below to verify that all parts have been shipped.
Procedure
1
2
3
4
Media and Additional Parts
Description
Operator's Manual
Engine operator's manual
Parts Catalog
Operator training material
1
Installing the PTO Driveshaft
to an Optional Mower Deck or
QAS
Parts needed for this procedure:
1 PTO driveshaft
4
Bolt (5/16 x 1-3/4 inches)
4 Locknut (5/16 inch)
2 Roll pin (3/16 x 1-1/2 inches)
Procedure
Note: Installing the PTO driveshaft is easier if you position
the machine on a hoist.
1. Park machine on a level surface, shut off the engine,
engage the parking brake, and remove key from the
ignition switch.
Description
PTO driveshaft
Bolt (5/16 x 1-3/4 inches)
Locknut (5/16 inch)
Roll pin (3/16 x 1-1/2 inches)
Retainer pin
Grease fitting
Washer head screw (5/16 x 7/8 inch)
No parts required
No parts required
Qty.
1
4
4
2
2
2
2
–
–
Qty.
1 Read before operating the machine
1 Read before operating the machine
1 Use reference part numbers
1 View the video before operating the machine.
WARNING
Do not start the engine and engage the
PTO switch when the PTO driveshaft is
disconnected from the cutting deck. If you
start the engine and the PTO shaft is allowed
to rotate, serious personal injury and machine
damage could result. Before the PTO
driveshaft is disconnected from the cutting
deck, disconnect the PTO solenoid-valve-coil
connector from the wire harness to prevent
unintentionally engaging the PTO clutch.
2. Disconnect the wire-harness connector from the PTO
solenoid-valve-coil connector
10
Use
Install the PTO driveshaft to a optional
deck or QAS.
Use the hardware to install the optional
mower deck.
Check the tire pressure.
Check the hydraulic fluid, engine oil,
and coolant levels.
Use
(Figure 3).