4. Reinstall the stud nut and washer (Fig. 20).
5. Repeat the adjustment on the other gage wheels.
4
3
2
Figure 20
1. Gage wheel
2. Stud
3. Washer
Adjusting the Center Rollers
1. Disengage the power take off (PTO) and turn the
ignition key to Off. Move the control levers to the
neutral locked position and apply the parking brake.
1. After adjusting the height-of-cut, remove the bolt and
nut (Fig. 21).
2. Select a hole so that the gage wheel is positioned to the
nearest corresponding height-of-cut desired (Fig. 21).
Note: Do not adjust the rollers to support the deck.
3. Reinstall the bolt, center rollers, and nut (Fig. 21).
3
1
Figure 21
1. Center rollers and spacer
2. Nut
1
5
m–4167
4. Nut
5. Wheel nut and washer.
Do not remove.
2
m–4124
3. Bolt
22
Positioning the Seat
The seat can move forward and backward. Position the seat
where you have the best control of the machine and are
most comfortable.
1. To adjust, move the lever sideways to unlock seat
(Fig. 22).
2. Slide the seat to the desired position and release the
lever to lock the seat in position.
1
Figure 22
1. Adjustment lever
m–3655