Cleaning And Storage - Toro 74256 Operator's Manual

Cleaning and Storage

1. Disengage the power take off (PTO), set the parking
brake and turn the ignition key to off. Remove spark
plug wire. Remove the key.
2. Remove grass clippings, dirt, and grime from the
external parts of the entire machine, especially the
engine and hydraulic system. Clean dirt and chaff from
the outside of the engine's cylinder head fins and
blower housing.
Important
You can wash the machine with mild
detergent and water. Do not pressure wash the machine.
Avoid excessive use of water, especially near the control
panel, engine, hydraulic pumps and motors.
3. Service the air cleaner; refer to Servicing the Air
Cleaner, page 33.
4. Grease and oil the machine; refer to Greasing and
Lubrication, page 37.
5. Change the crankcase oil; refer to Servicing the
Engine Oil, page 34.
6. Change the hydraulic filter; refer to Servicing the
Hydraulic System, page 40.
7. Check the tire pressure; refer to Checking the Tire
Pressure, page 38.
8. Scrape any heavy buildup of grass and dirt from the
underside of the mower, then wash the mower with a
garden hose.
Note: Run the machine with the PTO engaged and the
engine at high idle for 2 to 5 minutes after washing.
9. Check the condition of the blades. Refer to Servicing
the Cutting Blades on page 31.
10. Prepare the machine for storage when non–use occurs
over 30 days. Prepare machine for storage as follows.
A. Add a petroleum based stabilizer/conditioner to
fuel in the tank. Follow mixing instructions from
stabilizer manufacture. Do not use an alcohol
based stabilizer (ethanol or methanol).
Note: A fuel stabilizer/conditioner is most effective when
mixed with fresh gasoline and used at all times.
B. Run the engine to distribute the conditioned fuel
through the fuel system (5 minutes).
Important
Do not store stabilizer/conditioned gasoline
over 90 days.
11. Remove the spark plug(s) and check its condition;
refer to Servicing the Spark Plug, page 36. With the
spark plug(s) removed from the engine, pour two
tablespoons of engine oil into the spark plug hole.
Now use the starter to crank the engine and distribute
the oil inside the cylinder. Install the spark plug(s). Do
not install the wire on the spark plug(s).
12. Charge the battery; refer to Servicing the Battery
page 45.
Note: Disconnect the negative battery cable before storing
the machine.
13. Check and tighten all bolts, nuts, and screws. Repair or
replace any part that is damaged or defective.
14. Paint all scratched or bare metal surfaces. Paint is
available from your Authorized Service Dealer.
15. Store the machine in a clean, dry garage or storage
area. Remove the key from the ignition switch and
keep it out of reach of children or other unauthorized
users. Cover the machine to protect it and keep it
clean.
54