Toro 74256 Operator's Manual page 28

1. Raise the mower to the transport position.
2. Remove the bracket pin (Fig. 30).
2
5
1
3
Figure 30
1. Z Stand
2. Latch
3. Bracket
1
2
Figure 31
1. Z Stand (Positioned in
slot)
3. Raise the latch. Swing the stand foot out front and
slide stand toward machine, into the bottom of slot
(Fig. 30 and 31).
4. Set the foot of stand on the ground and rest the latch
on the pivot tab (Fig. 31).
5. Start the engine and put it at half throttle.
Note: For best results, place the foot of stand into seams
in sidewalks or into the turf (Fig. 31).
6. Drive onto the stand. Stop when the latch drops over
the tab into the locked position (Fig. 31). Once onto
the stand, engage the parking brake and tun off the
engine.
7. Chock or block the drive wheels.
4
m–5599
4. Bracket Pin
5. Bottom of slot
3
m–5600
2. Crack in side walk or turf
3. Latch resting on pivot tab
28
Warning
Parking brake may not hold machine parked on
Z Stand and could cause personal injury or
property damage.
Do not park on Z Stand unless wheels are chocked
or blocked.
8. Perform the maintenance.
Driving off the Z Stand
1. Remove the chocks or blocks.
2. Raise the latch to the unlocked position (Fig. 32).
3. Start the engine and place it at half throttle. Disengage
the parking brake.
4. Slowly drive backwards off of the stand.
5. Return the stand to its rest position (Fig. 30).
4
2
1
Figure 32
1. Z Stand
2. Latch
3
m–5601
3. Locked position
4. Unlocked position