Maintenance; Recommended Maintenance Schedule(S) - Toro 03706 Operator's Manual

Maintenance

Note: Determine the left and right sides of the machine from the normal operating position.

Recommended Maintenance Schedule(s)

Maintenance Service
Interval
After the first 10 hours
After the first 50 hours
Before each use or daily
Every 50 hours
Every 100 hours
Every 150 hours
Every 200 hours
Every 400 hours
Every 800 hours
Every 1,500 hours
Before storage
Every 2 years
Maintenance Procedure
• Check the fan and alternator belt tension.
• Torque the wheel lug nuts.
• Change the engine oil and filter.
• Check the planetary gear drive oil level.
• Change the hydraulic filter.
• Lubricate the reel speed valve with oil.
• Check the engine RPM (idle and full throttle).
• Check the engine oil level.
• Check the level of the coolant in the cooling system.
• Check the hydraulic fluid level.
• Check the reel to bedknife contact.
• Check the warning indicator lights.
• Check the safety interlock system.
• Drain the fuel filter/water separator.
• Remove debris from the screen, oil coolers, and radiator (more frequently in dirty
operating conditions).
• Check the hydraulic lines and hoses for leaks, kinked lines, loose mounting supports,
wear, loose fittings, weather deterioration, and chemical deterioration.
• Grease the bearings and bushings. (Grease them immediately after every washing
regardless of the interval listed.)
• Check the condition of and clean the battery.
• Check the battery cable connections.
• Inspect the cooling system hoses.
• Check the condition and tension of the alternator belt.
• Drain water from the hydraulic reservoir.
• Change the engine oil and filter.
• Service the air cleaner. (More frequently in extremely dirty or dusty conditions)
• Torque the wheel lug nuts.
• Drain moisture from the fuel and hydraulic fluid tanks.
• Check the cutting unit reel drive belts.
• Check the fuel lines and connections for deterioration, damage, or loose connections.
• Replace the fuel filter canister.
• Check the engine RPM (idle and full throttle).
• Drain and clean the fuel tank
• Check the rear wheel toe-in.
• Check the planetary gear drive oil level.
• Flush and replace the cooling system fluid.
• Change the hydraulic filter.
• Change the hydraulic system breather. (More often in extremely dusty or dirty
conditions)
• Pack the rear wheel bearings
• Adjust the engine valves (refer to the engine Operator's Manual)
• Change the hydraulic fluid.
• Drain and clean the fuel tank
• Replace all moving hoses.
26