Toro 03706 Operator's Manual page 24

1
Figure 23
1. Ground speed limiter
1
Figure 24
1. Reel speed control
Start the engine and move the throttle to the Fast
position. Disengage the parking brake. To move
forward, press the traction pedal forward (Figure 23).
Move the Mow-Backlap lever to the Mow position. The
reels are now spinning. Maintain traction pedal contact
with the ground speed limiter (Figure 23) to ensure
consistent clip and quality-of-cut.
CAUTION
This product may exceed noise levels of 85 dB(A)
at the operator position. Ear protectors are
recommended for prolonged exposure to reduce
the potential of permanent hearing damage.
Transport
When mowing is complete, move the Mow-Backlap
lever to the Stop position. Raise the cutting units by
pulling back on the lift control levers. Hold the levers
2
G012297
2. Traction pedal
G012298
back until the cutting units are fully raised (a squeal
from the hydraulic system means the cutting units are
fully raised). Lock the cutting units in place with the
transport latches. Be careful when driving between
objects so you do not accidentally damage the machine
or cutting units.
Matching Ground Speed and Reel
Speed
Vary reel speed (while maintaining constant ground
speed) to establish the best quality of cut for the area
being mowed. Reel speeds either too fast or too slow
for conditions may effect the quality of cut. Use the
appropriate cutting chart (below) and the decal on
steering console as a guide for initial adjustment of
ground and reel speeds.
Relate HOC and ground speed to required reel speed
setting on a 1 thru 5 scale on reel speed knob.
Note: 1 = 800 RPM; 2 = 900 RPM; 3 = 1000 RPM;
4 = 1100 RPM; and 5 = 1200 RPM. (Speeds are
approximate)
Note: In the following tables, N/R means Not
Recommended.
Note: Positions 4 and 5 are only attainable with a
special coupler (Part Number 58-1530). Contact your
Toro Dealer for information.
Recommended Reel Speed Settings: 5 Blade Reel
HOC
3
1 1
1.25 N/R
1.5 N/R
2 N/R
2.5 N/R
Recommended Reel Speed Settings: 7 Blade Reel
HOC
3
1/2 2
5/8 1
3/4 N/R
1 N/R
1.25
N/R
Recommended Reel Speed Settings: 11 Blade Reel
24
Ground Speed In MPH
4 5 6
3 5 N/R
1 3 5
N/R 2 3
N/R N/R 1
N/R N/R N/R
Ground Speed In MPH
4 5 6
5 N/R N/R
3 5 N/R
1 3 5
N/R 1 2
1
N/R N/R
7
N/R
N/R
4
2
1
7
N/R
N/R
N/R
3
2