Toro 71209 Operator's Manual page 40

Problem
The engine overheats.
There is an abnormal vibration.
The blade does not rotate.
The tractor does not drive.
The cutting height is uneven. g g
Possible Causes
1. The engine load is excessive.
2. The oil level in the crankcase is
low.
3. The cooling fins and air
passages under the engine
blower housing are plugged.
1. The blade is bent or
unbalanced.
2. The blade mounting bolt is
loose.
3. The engine mounting bolts are
loose.
4. There is a loose engine pulley,
idler pulley, or blade pulley.
5. The engine pulley is damaged.
1. The blade drive belt is worn,
loose, or broken.
2. The blade drive belt is off of the
pulley.
1. The traction belt is worn, loose,
or broken.
2. The traction belt is off the
pulley.
3. The transmission does not
shift.
1. The tire pressure is incorrect.
2. The mower is not level.
3. The underside of the mower is
dirty.
40
Corrective Action
1. Shift into a lower gear to
reduce the ground speed.
2. Add oil to the crankcase.
3. Remove the obstruction from
the cooling fins and air
passages.
1. Install a new blade.
2. Tighten the blade mounting
bolt.
3. Tighten the engine mounting
bolts.
4. Tighten the appropriate pulley.
5. Contact an Authorized Service
Dealer.
1. Install a new blade drive belt.
2. Install the blade drive belt and
check the idler pulley and belt
guides for the correct position.
1. Contact an Authorized Service
Dealer.
2. Contact an Authorized Service
Dealer.
3. Contact an Authorized Service
Dealer.
1. Set the tire pressure.
2. Level the mower from side to
side and from front to rear.
3. Clean the underside of the
mower.