Electrical System Maintenance; Battery Care - Toro 30412 Groundsmaster 4000-D Operator's Manual

4. Tighten the tube connector securely.
5. Repeat the procedure on the remaining nozzles.
Electrical System
Maintenance

Battery Care

Battery type is group 24.
Important: Before welding on the machine,
disconnect the negative cable from the battery to
prevent damage to the electrical system.
Note: Check the battery condition weekly or after every
50 hours of operation. Keep the terminals and the entire
battery case clean because a dirty battery will discharge
slowly. To clean the battery, wash the entire case with
a solution of baking soda and water. Rinse with clear
water. Coat the battery posts and cable connectors with
Grafo 112X (skin-over) grease (Toro Part No. 505-47)
or petroleum jelly to prevent corrosion.
CALIFORNIA
Proposition 65 Warning
Battery posts, terminals, and related
accessories contain lead and lead compounds,
chemicals known to the State of California
to cause cancer and reproductive harm.
Wash hands after handling.
1. Raise the seat and secure it with the prop rod.
2. Remove the battery cover (Figure 53).
40
Warning