Toro 315-8 User Manual page 160

GLOSSARY
This component provides the proper switching for
the starter, ignition, accessories, and safety circuits
(Figure 18).
Detents inside the switch give it 4 positions: STOP,
REVERSE CAUTION, NORMAL MOWING, and
START. The START position is spring loaded so the
cylinder automatically returns to NORMAL MOWING
once the key is released.
1. Disconnect the switch from the wiring harness.
2. Verify that continuity exists between the terminals
listed for each switch position. Verify that there is
NO continuity between terminals not listed for the
switch position (Figure 19).
G
S
M
Position
Off
Reverse Caution (Run 1)
Normal Mowing (Run 2)
Start
keysw
The reverse switch is attached to the underside of the
tractor next to the reverse lever (Figure 20).
L
A1
A2
B
swign
Condition
G+M+A1
B+A 1 & L+A 2
B+A 1
B+S+A 1
trevsw