Replacement Parts - Cub Cadet XT1 Operator's Manual
Enduro series
Hide thumbs
Also See for XT1:
- Operator's manual (72 pages) ,
- Operator's manual (76 pages) ,
- Operator's manual (76 pages)
Table of Contents
Advertisement
Replacement Parts
Component
Phone (800) 965-4CUB to order replacement parts or a complete Parts Manual (have your full model number and serial number
ready). Parts Manual downloads are also available free of charge at www.cubcadet.com.
Part Number and Description
954-05099
Deck Belt, 42" Deck
954-05087A
Deck Belt, 46" Deck
954-04077A
Deck Belt, 50" Deck
954-05025A
Deck Belt, 54" Deck
942-04308
Blades, 42"
942-04308-X
Xtreme Blades, 42"
942-04244A
Blades, 46"
942-04290-X
Xtreme Blades, 46"
942-05052A
Blades, 50"
942-05056A
Blades, 54"
918-06976
Deck Spindle, 42"
918-06977
Deck Spindle, 46"
918-06980
Deck Spindle, 50"
918-06979
Deck Spindle, 54"
734-04155
Front Deck Wheel
734-0973
Rear Deck Wheel (Manual PTO tractors
& LX 46)
731-05679B
Nose Roller (50" Stamped, 54" FAB &
54" Stamped Decks)
925-1707D
Battery
951-14767
Gas Cap
946-05097A
Throttle/Choke Control Cable
(Kohler Single Engine)
946-05098B
Throttle/Choke Control Cable
(Kohler Twin Engine)
946-05223
Throttle Control Cable
(Kohler Twin Engine)
946-05225
Choke Control Cable
(Kohler Twin Engine)
946-05095
Throttle Control Cable
(Kawasaki Twin Engine)
946-05114A
Choke Control Cable
(Kawasaki Twin Engine)
9
31
Hide quick links:
Advertisement
Table of Contents
Need help?
Do you have a question about the XT1 and is the answer not in the manual?
Questions and answers
can i get a owners manual from cub cadet
You can obtain an owner's manual for the Cub Cadet XT1 by downloading it from the Cub Cadet website. Look for the manual using the model number of your tractor, which is 11 characters long and printed on the left side of the Product Identification Label.
This answer is automatically generated
Where is the voltage regulator located
Buongiorno vorrei sapere come si smonta il multing grazie
To remove the mulching attachment on a Cub Cadet XT1, follow these steps:
1. Lower the Mower Deck – Use the height adjustment lever to drop the deck to its lowest position.
2. Remove the Mulching Plug – The kit includes a plug that blocks the discharge chute. Pull out the plug from the chute.
3. Replace the Mulching Blades – If mulching blades were installed, you will need to remove them and replace them with standard blades. This typically involves removing the blade nuts using a wrench.
4. Reattach the Discharge Chute – If the chute was secured out of the way, release it back into its normal position.
Ensure the mower is turned off and the blades have stopped moving before performing any maintenance.
This answer is automatically generated
What's the black box downstream of the fuel filter?
The black box located downstream of the fuel filter on a Cub Cadet XT1 is likely the carburetor. The fuel filter is installed between the gas tank and the carburetor to filter the fuel before it reaches the engine.
This answer is automatically generated
My xt-1 acts as if it’s in low gear
Your Cub Cadet XT1 may act as if it’s in low gear due to a bad transmission. According to the context, the issue worsens over time and is eventually confirmed by fluid leaking from the bottom. This indicates that the transmission is failing, which can cause a loss of power and poor drive performance even when the engine runs normally.
This answer is automatically generated
Where is the cruise control lever on ct1?
The cruise control lever on the Cub Cadet XT1 is combined with the parking brake lever.
This answer is automatically generated
suspect ignition switch problem. Motor will inadvertently start to shut down. By manipulation of key in switch, I can sometimes keep motor running. Other times the motor shuts down and then I can restart it.
si le compteur indique 181.5 le moteur a combien d'heure
What grade of oil??