Troubleshooting - Samsung GN641FDXD1 Installation And User Manual

Cleaning and Maintenance (Continued)
BURNERS
■ Remove the burner lids and Flame Spreaders by pulling them upwards and away
from the top plate.
■ Soak them in hot water and a little detergent.
■ After cleaning and washing them, wipe and dry them carefully. Make sure that the
flame holes are clean and completely dry.
■ Wipe the fixed parts of the burner cup with a damp cloth and dry afterwards.
■ Gently wipe the Ignition device and flame supervision device with a well wrung-out
cloth and wipe dry with a clean cloth.
■ Before placing the burners back on the top plate, make sure that the injector is not
blocked.
■ Re-assemble the Auxiliary, Semi-Rapid and Rapid burners
as follows :
1. Place the flame spreader (20) on to the burner cup (21) so that the ignition device and the flame
supervision device extend through their respective holes in the flame spreader. The flame spreader
must click into place correctly.
2. Replace the burner lid (19, 19-1 & 19-2) ensuring that the locating tabs fit into the noches in the
flame spreader (20).
Replace parts in the correct order after cleaning.
- Do not mix up the top and bottom.
- The locating lugs must fit exactly into the notches.
19-1
19
19-2
20
21
16

Troubleshooting

■ Repairs to the gas and electrical components of this appliance must only be carried out by
a suitably qualified and competent person to ensure safety.
■ However, some minor problems can be resolved as follows :
Problem Probable cause
Not ignited
No Spark.
The burner lid is badly assembled.
The middle valve is closed.
Badly ignited The middle valve is incompletely
opened.
The burner lid is badly assembled.
The ignition plug is contaminated
with alien substance.
The burners are wet.
The holes in the flame spreader
are clogged.
Noise made when
The burner lid is badly assembled.
combusted and ignited
The flame supervision device is
Fire off while using
contaminated with alien substance.
Yellow Flame The holes in the flame spreader
are clogged.
Different gas is used.
Unstable Flame
The burner lid is badly assembled.
A gas tap has been left on.
Gas Smell
There may be a leak between
the coupling and the gas bottle.
■ If problem is not solved, please contact the Samsung customer care
center.
Solution
Check the electricity supply
Assemble the lid correctly.
Open the middle valve
completely.
Open the middle valve
completely.
Assemble the lid correctly.
Wipe such alien substance with
dried clothing.
Dry the burners lids carefully.
Clean the flame spreader.
Assemble the burner lid
correctly.
Clean the flame supervision
device.
Clean the flame spreader.
Check the gas used.
Assemble the burner lid
correctly.
Check to see if any gas taps are
on.
Make sure that the connection is
airtight.
17