Basic Connections
This section explains all connections needed to make and receive IP line and TEL line calls.
•
To connect a Portable Station (PS) to the unit, see page 44.
•
To connect a computer to the unit, see page 45 or page 46.
1.
Connect the unit to the desired IP network and/or telephone line.
•
To connect to an IP network, connect a category 5 LAN cable to the LAN port and to a switching hub.
•
To connect to a telephone line, connect a telephone cord to the LINE jack and to a modular telephone
jack.
2.
Connect the AC adaptor cord of the included AC adaptor to the unit's DC input.
•
To use PoE (Power over Ethernet), connect the LAN cable to a PoE-compatible (IEEE802.3af)
switching hub or power supply. The included AC adaptor does not need to be connected when using
PoE.
•
If using an AC adaptor, use only the included AC adaptor (PQLV206).
•
Pass the AC adaptor cord through the groove on the bottom of the unit.
3.
Connect the AC adaptor to the AC outlet.
Note
•
The AC adaptor must remain connected at all times (unless the unit is powered by PoE). It is normal
for the adaptor to feel warm during use.
Document Version
2011/06
LINE
LAN
DC IN
A
B
C
A AC Adaptor Cord
B LAN Cable
C 2-conductor Telephone
Cord
D To AC Outlet
E To Switching Hub
F
F Groove
D
G Telephone Jack or PBX
(RJ11C)
E
G
Operating Instructions
Preparation
25