NorthStar Explorer 710 VHF Operation And Installation Manual page 55

Connect the Radio Cables - Rear view of base unit
2
3
4
1. VHF Antenna connection. (Antenna is not supplied.)
2. Combined power and speaker cable. The end of the power cable splits in two:
BLACK. Earth. Connect to the (-) NEGATIVE battery terminal.
RED. Power. Connect to the (+) POSITIVE battery terminal. Check that a 10A fuse is installed on this
power cable, close to the battery.
3. External speaker cable.
4. GPS connector cable.
Wiring Details
In case a cable is cut accidentally the pinouts are shown here for information only.
Do not cut cables intentionally.
Cable
1 VHF Antenna
2 Power
3 External speaker
4 GPS connector (pins used)
Pinout
1. 13.6V DC +
2. 13.6V DC -
1. EXTERNAL SPK +
2. EXTERNAL SPK -
4. NMEA IN +
5. NMEA IN -
2. NMEA OUT +
6. NMEA OUT -
Northtstar Explorer VHF Series: 710US, 710EU Operation and Installation Manual
Color
Red (thick cable)
Black (thick cable)
White (thin cable)
Black (thin cable)
Yellow
Green
Orange
Black
1
55