NorthStar Explorer 710 VHF Operation And Installation Manual page 16

2-5-3 Time Format Options (TIME FORMAT)
Time can be shown in 12 or 24 hour format.
GPS/DATA
MANUAL
> SETTING
1. Select GPS/DATA, then SETTING.
2. Select TIME FORMAT.
3. Select 12 Hr or 24 Hr as desired. In this example, 12 hour format has been selected and so the LCD
shows the AM or PM suffix.
2-5-4 Time Display Options (TIME DISPLAY)
If you have entered the time manually as described in the previous sections, the time is always shown on
the screen with the prefi x M.
However, if the vessel position is being updated through a GPS navigation receiver, you can switch the time
display on the screen ON or OFF as follows:
GPS/DATA
TIME OFFSET
TIME FORMAT
> TIME DISPLY
If the time display is set ON, course and speed data are not displayed on the LCD (see
section 2-5-6).
2-5-5 Position Display Options (LL display)
If you have entered the vessel position manually as described in the previous section, the vessel position is
always shown on the screen with the suffi x M.
However, if the time is being updated through a GPS navigation receiver, you can switch the vessel position
display on the screen on or off as follows:
GPS/DATA
TIME FORMAT
TIME DISPLY
> LL DISPLAY
2-5-6 Course & Speed Display Options (COG/SOG)
Use this option to display course over ground (COG) and speed over ground (SOG) data on the screen.
GPS/DATA
TIME DISPLY
LL DISPLY
> COG/SOG
If GOG/SOG is set ON (on), the time is not displayed on the screen (see section 2-5-4).
16
SETTING
TIME OFFSET
> TIME FORMAT
TIME DISPLAY
TIME DISPLY
ON
> OFF
LL DISPLAY
ON
> OFF
COG/SOG
> ON
OFF
Northtstar Explorer VHF Series: 710US, 710EU Operation and Installation Manual
TIME FORMAT
> 12 Hr
24 Hr
07:15AM LOC
1. Select GPS/DATA, then SETTING.
2. Select TIME DISPLAY.
3. Select ON (on) or OFF (off ) as desired. In this
example, OFF has been selected and so the
screen no longer shows the time.
1. Select GPS/DATA, then SETTING.
2. Select LL DISPLAY.
3. Select ON (on) or OFF (off ) as desired. In this
example, OFF has been selected and the screen
no longer shows the vessel position.
1. Select GPS/DATA, then SETTING.
2. Select COG/SOG.
3. Select ON (on) or OFF (off ) as desired. In this
example, ON has been selected and so the
screen shows the bearing and speed.