Troubleshooting - Kemppi MinarcTig 180 Operating Manual

Shielding gas hose (4.5 m)
Carrying straps
Remote control units
R 10
R11F
Mains cable (MinarcTig 250)
7.

trOuBleshOOting

Problem
The main switch indicator will
not light up
Poor welding result
Overheating indicator lit
If the machine's malfunction is not eliminated with these measures, contact
KEMPPI service.
© Kemppi Oy / 1339
W001077
9592162
6185409
6185407
W002982
Cause
No electricity connected to the machine
• Check the mains supply fuses.
• Check the mains cable and plug.
Several factors affect the welding quality.
• Check that the earthing clamp is properly attached, the
point of attachment is clean and that the cable and its
connectors are intact.
• Check that the shielding gas flows out of the torch tip.
• The electric network voltage is irregular, too low or too
high.
The device has overheated.
• Ensure that cooling air has unrestricted flow.
• The machine's duty cycle has been exceeded. Wait for
indicator to turn off.
• Too low or high supply voltage.
EN
19 19