Indicators And Keys; Local Management Interface - Nokia DNT2Mi sp/mp Operating Instructions Manual

4.1.1

Indicators and keys

Multiport DNT2Mi
Single-port DNT2Mi
4.1.2

Local management interface

16 (128)
Data Network Terminal Single-port and Multiport Operating Instructions
STATUS P1 P3
PWR TEST P2
STATUS PORT
PWR TEST
1. LED
indicators
Figure 4. Indicators and keys of the two DNT2Mi units
The local management interface is located behind the front panel door (see Figure
5). The interface is used to manage DNT2Mi with Macro Service Terminal
Emulator (MSTE) running on a PC or with other Nokia management software.
If signal 108 (DTR) is on, connecting the Service Terminal Emulator will
disconnect DNT2Mi from the remote network management. If signal 108 is off,
the entire network can be managed through this equipment.
Management interface cables of DNT2Mi are listed in Table 1.
Electrically, management interface signals comply with ITU-T V.28 or V.11. The
selection is made using either front panel menus or Q1 menus.
© Nokia Corporation
Nokia Proprietary and Confidential
DTR DSR DCD RTS CTS
DTR DSR DCD RTS CTS
2. LCD
display
OK EXIT
DNT2Mi
OK EXIT
DNT2Mi
3. Front
panel keys
DN01145897
Issue 2-0 en