Magnifying Part Of The Image (Viewer Ptz) - Canon VB-H43 Operation Manual

Magnifying Part of the Image (Viewer
PTZ)
You can use the Viewer PTZ panel to magnify part of the
camera's image in the video display area.
Viewer PTZ
Viewer PTZ uses the digital zoom function to enlarge part
of a video without using the camera pan, tilt or zoom
functions.
This function allows you to enlarge part of a video when
using the camera in a locked position, for example, during
use of an intelligent function.
Important
When the Viewer PTZ function is used, you cannot operate the
camera by clicking/dragging the video display area.
Note
• Video cropped with Viewer PTZ will not be videos recorded
manually, or by event or timer.
• The cropped position in the video display area will be reflected
in full screen mode as well.
Opening the Viewer PTZ Panel
Click the [Viewer PTZ] button to display the viewer PTZ
panel.
The [Viewer PTZ] button appearance will change as
follows depending on the status of the Viewer PTZ
function.
Viewer PTZ disabled (video being received by
the camera appears in the video display area)
Viewer PTZ enabled (magnified video appears in
the video display area)
The initial status of the Viewer PTZ panel shows the
preview frame (yellow) occupying the entire image.
Adjusting the Preview Frame Size
Drag the preview frame line to make the frame smaller,
and a magnified view of the image in the frame will be
shown in the video display area.
The preview frame turns blue when you drag it.
You can also click and drag outside the preview frame to
draw a new preview frame.
Note
The Viewer PTZ uses digital zoom, so the higher the digital zoom
ratio, the lower the quality of the image becomes.
How to Operate the Viewer
Preview Frame
(Magnified display area)
Center of preview
frame
145
6