First Start-Up And Calibration; Test Docking With The Charging Station - Husqvarna 420 Operator's Manual

3.8 First Start-up and Calibration

Before the robotic lawnmower is operated, a start-up
sequence in the robotic lawnmower's menu must be
carried out as well as an automatic calibration of the
guide signal.
1. Open the control panel cover by pressing the
STOP button.
2. Set the main switch to position 1.
A start-up sequence begins when the robotic lawnmower
is started for the first time. The following is requested:
• Language
• Country
• Date
• Time
• Four digit PIN code. All combinations except 0000
are permitted.
Dock the robotic lawnmower in the charging station and
press START.
The robotic lawnmower will now begin to calibrate the
cutting height adjustment. When this is complete the
guide wires will be calibrated. Press START and close
the cover. The calibration is performed by the robotic
lawnmower backing out of the charging station and
running a calibration process in front of the charging
station. When this is completed, mowing can begin.
IMPORTANT INFORMATION
Use Memo on page 2 to make a note of
the PIN code.
3.9 Test Docking with the Charging
Station
Before using the robotic lawnmower, check that the
robotic lawnmower can follow the guide wire all the way
to the charging station and easily docks with the charging
station.
The test function is in the robotic lawnmower Installation
> Find charging stations > Guide > More > Test Guide X
menu. For more information, see More > Test on page 58.
If more than one guide wire is installed, the test must be
carried out on all guide wires.
If no guide wire is installed the test must be carried out on
the boundary wire, both clockwise and anti-clockwise.
The guide system must first be calibrated if the above test
is to provide a satisfactory result, see 3.8 First Start-up
and Calibration on page 32.
English - 32
1157866-26,420,430X,450X,EN_160314.indd 32
INSTALLATION
2016-03-14 16:58:50