Operation Mode; Use The Setting Dial Like A Potentiometer To Perform Operation - Mitsubishi Electric F700 Instruction Manual

3.4.2

Use the setting dial like a potentiometer to perform operation.

POINT
Set "0" (extended mode parameter valid) in Pr. 160 User group read selection.
Set "1" (setting dial potentiometer mode) in Pr. 161 Frequency setting/key lock operation selection.
Operation example Change the frequency from 0Hz to 50Hz during operation
1.
Screen at powering on
The monitor display appears.
2.
Press to choose the PU operation
mode.
3.
Press to choose the parameter
setting mode.
4.
Turn until
5.
Press to read the currently set value.
" " (initial value) appears.
6.
Turn to change it to
the setting value "
7.
Press to set.
8.
Change Pr. 161 to the setting value of "
in the similar manner. (Refer to step 4 to 7.)
9.
Mode/monitor check
Press twice to choose
monitor/frequency monitor.
10.
Press (or
11.
Turn until "
The flickering frequency is the set frequency.
You need not press
REMARKS
· If flickering "50.00" turns to "0.0", the Pr. 161 Frequency setting/key lock operation selection setting may not be "1".
· Independently of whether the inverter is running or at a stop, the frequency can be set by merely turning
Operation
(Pr. 160) appears.
".
"
) to start the inverter.
" appears.
.
Start/stop from the operation panel (PU
Display
PU indication is lit.
The parameter number
previously read appears.
Flicker ··· Parameter setting complete!!
Flicker ··· Parameter setting complete!!
The frequency flickers for about 5s.

operation mode)

.
35
3