Uploading Blade Configuration - NEC UNIVERGE SV9100 Programming Manual

ISSUE 2.0
4.3
SV9100 PC Programming Manual
4.2.1 Transfer Type
Select a filter that controls the scope of chassis settings to upload. The
following Transfer Types are made available.
All: No filter, all Chassis settings.

Blade Configuration: Blade packages settings.

System Data Partial (System Wide): System-based settings.

System Data Partial (Telephone): Telephone-based settings.

System Data Partial (Virtual Extension): Virtual Extension-based

settings.
System Data Partial (Trunk): Trunk-based settings.

Transfer Type Items
Specifically select PRG Groups and/or individual PRGs from the
chassis settings to upload. The choice of Transfer Type Items
available is governed by the Transfer Type selected.
Modify Filters
A filter is applied based on the system data modification status. The
filter only applies to system data on the PCPro side, not system data
residing in chassis memory. Refer to
further information.

Uploading Blade Configuration

When uploading the Blade Configuration via Upload All, and selecting Card
Configuration, or just Uploading Card Configuration, a warning popup will
display when either Trunks or stations are busy at the time of selecting to
uploading the Card Configuration. This will allow for the upload to be canceled
and completed at a later time, or to be continued and will disconnect the busy
trunks and/or stations.
- Modification History for
B-15