Disassembly Procedures - Yamaha DVD-C996 Service Manual

DVD-C996/DV-C6280

DISASSEMBLY PROCEDURES

1. Removal of Top Cover
a. Remove 4 screws ( q ) and also 3 screws ( w ) in
Fig. 1.
2. Removal of Tray Ass'y
a. Remove 1 screw ( e ) in Fig. 1.
b. Turn Gear/L0 as shown in Fig. 2 counter clockwise
gradually till immediately before the tray starts to
move and stop it there.
CAUTION: Gear/L0, if turned counter clockwise con-
tinuously, will mesh with the gear of the tray
and the tray will come out. When removing
the tray, use care so that Gear/L0 will not
mesh with the gear of the tray.
c. Pull out the Tray Ass'y.
Precaution for installation of the Tray Ass'y.
On Tray Ass'y setting.
Check the Direction of marking " " on gear
according to this drawing.
Gear/L01
3. Removal of Table
a. Remove 2 screws ( r ) and then remove the Roller
Ass'y in Fig. 3.
b. Remove the Plate/Table in Fig. 3.
c. Remove 1 screw ( t ) and then take off the Table in
Fig. 3.
Fit the table to the thick line on "
t
Plate/Table
13
(Remove parts in the order as numbered.)
Gear/L0
Front Panel
Fig. A
Marking
/
" mark.
r
Fig. 3
Top Cover
q
Tray
e
Gear/L0
IMPORTANT: Installation of Table.
Install the table according to the following procedure.
1) Slide the Lever so that the Gear/RT becomes
free. (Fig.B)
2) With the " " mark on the Gear/RT aligned
with the same mark on the Tray, lock it with
the Lever. (Fig.B)
3) Install the Table by aligning it to the thick line
/
on " " mark. (Fig.3)
*Check that the Table is locked after installation.
Fit the Gear/RT to " " mark.
Gear/RT1
Tray
Lever
Lock
Unlock
w
q
Fig. 1
Tray
Fig. 2
Fig. B