Quick Start - NEC MultiSync MS125 User Manual

Quick Start

To attach the MultiSync
structions:
1. Turn off the power to your computer.
2. If necessary, install the display card into your system. For more information,
refer to the display card manual.
3. For the PC: Connect the one end of the 15-pin mini D-SUB of the video signal
cable to the rear of the monitor and the other end to the connector of the
display card in your system (Figure A.1). Tighten all screws.
For the Mac: Connect the Macintosh cable adapter (not included) to the
monitor connector on the Macintosh (Figure B.1). Attach the 15-pin mini
D-SUB end of the video signal cable to the Macintosh cable adapter on
the computer and the other end to the back of the monitor (Figure B.1).
Tighten all screws.
NOTE: To obtain the Macintosh cable adapter, call NEC Technologies
at (800) 820-1230.
4. Connect one end of the power cord to the MultiSync monitor and the other
end to the power outlet (Figure C.1).
5. Turn on the monitor (Figure D.1) and the computer.
NOTE: On the included floppy. Select the Windows
included on this disk.
NOTE: If you have any problems, please refer to the Troubleshooting section of
this User's Manual.
15-pin mini D-SUB
MS125 Manual.wpc
® monitor to your system, follow these in-
Figure A.1
3
5
95/98 INF files are
®
Video Signal Cable
5/7/01, 3:34 PM