On-Screen Message Descriptions; Fault Messages - Hitachi PB Series User Manual

6.2
* After cleaning, thor-
oughly wipe off the
makeup ink from the
surfaces of the com-
ponents with a piece
of wiping paper. Then,
dry the surfaces.
Section 6

On-screen Message Descriptions

6.2.1

Fault messages

6.2.1-1 Faults causing ink stoppage
No. Message
1 Ink Low
2 Ink Over Fill
3 Makeup Ink
4 Replenishment Time-out
5 Ink Drop Charge Too Low
6 No Ink Drop Charge
7 Noise fault C
8 Noise fault M
Meaning of message
The ink level in the ink
tank is too low. (If ink is not
added or replaced within
60 minutes after
indication of the warning,
the printer comes to a stop
with the warning condition
replaced by a fault
condition.)
The ink level in the main
ink tank is too high.
The makeup ink level in
the makeup ink tank is too
low (if replenishment is
not performed within
60 minutes after
indication of the warning)
The automatic
replenishment sequence
is taking too much time.
The ink particles are
poorly charged (charge
too low).
The particles are not
charged electrically.
The controller section
malfunctioned due to
noise.
Malfunction of the engine
section caused by noise.
6.2 On-screen Message Descriptions
Remedy
Add ink to the ink tank.
Drain ink from main ink
tank drain tube
Add makeup ink to the
makeup ink tank.
Contact your nearest
Hitachi distributor.
Clean the gutter,
deflection electrode,
and adjacent parts.
Adjust the excitation
setting to make sure
that the ink particles
are properly shaped.
Adjust the ink pres-
sure.
Check if the ink beam
is positioned approxi-
mately in the center of
the gutter.
Clean the gutter,
deflection electrode,
and adjacent parts.
Adjust the excitation
setting to make sure
that the ink particles
are properly shaped.
Check the ink pres-
sure.
Turn the power OFF
and then back ON.
Turn OFF the power
and then turn back
ON.
6–3