Register-Level Programming; Base Address; Table; Pc-Lpm-16/Pnp Register Map - National Instruments PC-LPM-16/PnP User Manual

Register-Level
Programming
Note:

Base Address

Register Map
Register Name
Configuration and Status Register Group
Command Register 1
Command Register 2
Command Register 3
Status Register 1
Status Register 2*
Analog Input Register Group
A/D FIFO Low-Byte Register
A/D FIFO High-Byte Register
A/D Clear Register
National Instruments Corporation
This appendix describes in detail information related to register-level
programming the PC-LPM-16/PnP.
If you plan to use a programming software package such as NI-DAQ,
LabVIEW, or LabWindows/CVI with your PC-LPM-16/PnP, you need not
read this appendix.
For information on the base address, see Chapter 2, Installation and
Configuration.
The register map for the PC-LPM-16/PnP is given in Table D-1. This
table gives the register name, the register address offset from the
board's base address, the type of the register (read only, write only, or
read and write), and the size of the register in bits.
Table D-1.

PC-LPM-16/PnP Register Map

Offset Address
(Hex)
0
7
5
0
1
2
3
1
D-1
Appendix
D
Type
Write-only
Read-and-write
Write-only
Read-only
Read-only
Read-only
Read-only
Write-only
PC-LPM-16/PnP User Manual
Size
8-bit
8-bit
8-bit
8-bit
8-bit
8-bit
8-bit
8-bit