Integrated Descaling Programme - Melitta CAFFEO LATTEA Operating Instructions Manual

11.4 Integrated descaling programme

The integrated descaling programme removes limescale in the interior of the
appliance. It requires a total of approximately 25 minutes. The symbol for descaling
flashes during the entire process.
Prerequisite: The appliance must be switched off (see „Switching on and off"
on page 51).
Caution!
– Carry out the integrated descaling programme every 3 months or when the
descaling symbol
– Only use Melitta
These descaling products are exactly designed for the Melitta
LATTEA .
®
– Never use vinegar or other descaling agents.
Run the integrated descaling programme as follows:
1 Before descaling, remove – if in use – the Melitta
from the water tank.
2 Remove the milk canister.
3 Simultaneously press both the button for two-cup dispensing
the ON/OFF button
→ The symbol for descaling
The symbol for the drip tray
Phase 1
During Phase 1, one bean symbol
4 Empty the drip tray and coffee grounds container.
5 Reinsert the drip tray without the coffee grounds container and place
the coffee grounds container under the milk shower.
→ The symbol for the water tank
6 Open up the flap of the water tank (Fig. A, no. 7) and pull the water tank
up and out of the appliance and then empty it completely.
illuminates on the display.
ANTI CALC Espresso Machines descaling agent.
®
for about 3 seconds.
is flashing.
is illuminated.
is shown on the display.
Claris
®
illuminates.
CAFFEO
® ®
water filter
®
and
69