Integrated Descaling Programme - Melitta Caffeo Solo & Milk Operating Instructions Manual

Integrated descaling programme

Warning!
The descaling agent can cause skin
irritations
Comply with the safety instructions
and the dosing information specified
on the descaling agent packaging.
The integrated descaling programme
(takes about 30 minutes) removes lime
residues inside the appliance. The symbol
for descaling flashes during the entire
process.
The descaling programme should be
performed every 3 months, however, at
the latest when illuminates ("Setting
the water hardness", page 23).
Only use Melitta ANTI CALC.
®
• Switch off the appliance.
• Pull the supplied hose approx. 1 cm over
the steam pipe (Image J) to prevent the
spraying of liquids.
• Place the coffee grounds container to
the right of the appliance. The hose
should protrude into the coffee grounds
container as shown in Image J.
• Remove the water filter if necessary
("Water hardness and filter", page 22).
• Press the and
simultaneously for ca. 3 seconds.
flashes, illuminates.
Descaling phase 1 (
• Empty and reinsert the drip tray.
illuminates.
• Completely empty the water reservoir.
• Add the descaling agent to the water
reservoir according to the instructions on
the packaging.
• Insert the water reservoir.
buttons
):
• Press the button to start the
descaling programme (takes about 15
minutes).
Descaling phase 2 (
When illuminates, proceed as follows:
• Ensure that the coffee grounds container
is placed under the steam pipe with the
hose.
• Turn the valve switch 11 clockwise until
the stop. is flashing. Water will flow
intermittently into the coffee grounds
container (takes about 10 minutes).
is then illuminated.
• Empty the drip tray and coffee grounds
container.
• Reinsert the drip tray and put the coffee
grounds container back under the steam
pipe. illuminates.
• Rinse the water reservoir thoroughly
with clear water.
• Fill the water reservoir with tap water up
to the max. mark.
• Insert the water reservoir.
• Press the button to continue with the
descaling programme.
Water flows into the coffee grounds
container.
Descaling phase 3 (
When illuminates, proceed as follows:
• Turn the valve switch 11
counterclockwise until the stop. Water
flows inside the appliance into the drip
tray.
• When is illuminated, empty the drip
tray and the coffee grounds container
and reinsert them. When
illuminated, the descaling programme is
finished.
• Insert the water filter if necessary
("Water hardness and filter", page 22).
):
is flashing.
):
is
25